Video Direct Corp Technology News

Posts Tagged ‘cisco’

To earn your CCNP certification and pass the BCMSN exam, you’ve got to know what HSRP does and the many configurable options. While the operation of HSRP is quite simple (and covered in a previous tutorial), you also need to know how HSRP arrives at the MAC address for the virtual router – as well as how to configure a new MAC for this virtual router. This puts us in the unusual position of creating a physical address for a router that doesn’t exist!

The output of show standby for a two-router HSRP configuration is shown below.

R2#show standby

Ethernet0 – Group 5

Local state is Standby, priority 100

Hellotime 3 sec, holdtime 10 sec

Next hello sent in 0.776

Virtual IP address is 172.12.23.10 configured

Active router is 172.12.23.3, priority 100 expires in 9.568

Standby router is local

1 state changes, last state change 00:00:22

R3#show standby

Ethernet0 – Group 5

Local state is Active, priority 100

Hellotime 3 sec, holdtime 10 sec

Next hello sent in 2.592

Virtual IP address is 172.12.23.10 configured

Active router is local

Standby router is 172.12.23.2 expires in 8.020

Virtual mac address is 0000.0c07.ac05

2 state changes, last state change 00:02:08

R3 is in Active state, while R2 is in Standby. The hosts are using the 172.12.123.10 address as their gateway, but R3 is actually handling the workload. R2 will take over if R3 becomes unavailable.

An IP address was assigned to the virtual router during the HSRP configuration process, but not a MAC address. However, there is a MAC address under the show standby output on R3, the active router. How did the HSRP process arrive at a MAC of 00-00-0c-07-ac-05?

Well, most of the work is already done before the configuration is even begun. The MAC address 00-00-0c-07-ac-xx is reserved for HSRP, and xx is the group number in hexadecimal. That’s a good skill to have for the exam, so make sure you’re comfortable with hex conversions. The group number is 5, which is expressed as 05 with a two-bit hex character. If the group number had been 17, we’d see 11 at the end of the MAC address – one unit of 16, one unit of 1.

The output of the show standby command also tells us that the HSRP speakers are sending Hellos every 3 seconds, with a 10-second holdtime. These values can be changed with the standby command, but HSRP speakers in the same group should have the same timers. You can even tie down the hello time to the millisecond, but it’s doubtful you’ll ever need to do that.
Read the rest of this entry »

Whether you’re on the road to the CCNA, CCNP, MCSE, or you’re on any other computer certification track, the odds are that sooner or later, you’re going to fail an exam. It’s happened to almost all of us, yours truly included. What you have to keep in mind in these times is that success is not a straight line. You’ve probably seen charts showing the growth of an industry or a business — you know, the ones that go from left to right, and look kind of jagged. The line goes up for a while, then down a bit, then up some more, then down a little.

The key? While every business has its setbacks, the net result is that the line goes up and progress is made. That’s how you want your certification pursuit and your career to go as well – upward!

I’m not asking you to be happy about failing an exam. You’re allowed to get mad for a few minutes, vow to never take another exam again, and be disappointed. What you’re not allowed to do is stay that way.
Read the rest of this entry »